​​​                Key Features


*Fast Drying ​                    

*No Mold Build-up        

*No Transfer to Part

*Single Application

*Convenient Application

*Reduced Downtime

*Rust Inhibitor for Molds Stored Outdoors


Copyright © Advanced Armor

​​

trúSLIP


truSLIP APPLICATION:

1.  Always shake trúSLIP well before and during use.

2.  Apply trúSLIP with a mop or a clean, lint free, 100% cotton cloth. truSLIP may also be applied with an airless sprayer or garden type sprayer.

3.  Allow trúSLIP to haze (dry). This usually takes around 5-10 minutes, depending on the temperature and ventilation. If you are going for a high-gloss finish, you may want to wipe or buff the trúSLIP after applying.

4.  Check mold for any region that appears uncoated (where truSLIP haze is not present). If any uncoated areas are observed, apply truSLIP in the above manner. After complete coverage has been achieved, the mold is ready for use. 


USES:

For use with metal, composite, plastic and other molds while creating the following:

  • Fiberglass products
  • Composite products
  • Concrete products
  • Foam products
  • Rubber products
  • And much more!


FIRST AID PROCEDURES Eye Contact: Flush with water for 15 minutes. If irritation persists, call a physician. Skin: Wash with soap and water. Ingestion: Seek medical attention. Do not induce vomiting unless directed by medical personnel. *Consult MSDS Prior to Use*


LIMITATIONS OF LIABILITY No guarantee of accuracy is given or implied. We guarantee our products to conform to Advanced Armor quality control. We assume no responsibility for coverage, performance, or injuries resulting from its use. Liability, if any, is limited to replacement of products. NO OTHER WARRANTY OR GUARANTEE OF ANY KIND IS MADE BY ADVADVANCED ARMOR, EXPRESSED OR IMPLIED, STATUTORY, BY OPERATION OF LAW OR OTHERWISE, INCLUDING FITNESS FOR A PARTICULAR PURPOSE.